Elgato Light Strip Pro — Quick Start Guide

The length of Light Strip Pro can be adjusted to accommodate your chosen application (maximum strip length 2000 mm | 78.8 in). To shorten Light Strip Pro, use a pair of scissors to bisect the oval copper pads.

Clean the mounting surface with a lint-free cloth. Peel back some of the protective film to expose a short section of the adhesive backing on Light Strip Pro, and stick to the mounting surface by applying pressure for 5 to 10 seconds. Slowly peel back the remaining film with one hand while using the other hand to press down newly exposed sections of the adhesive backing. Once fully mounted, run your fingertips firmly along the full length of Light Strip Pro to maximize bond strength. Use the additional tesa® adhesive strips to mount the controller.

Light Strip Pro and its controller are magnetic for glueless mounting on ferromagnetic metal surfaces.

• Light Strip Pro gets hot during use. Do not touch the LEDs while they are turned on.
• Indoor use only.
• Do not cover or mount anything on top of Light Strip Pro while in use.
• Exercise caution when using near small children.
• Do not expose directly to sunlight.
• Keep clean using a soft, dry cloth. Do not use benzene, thinner or other chemicals.
• Use for intended purpose only.
• Use only manufacturer recommended accessories.

Download and install the Control Center app for Mac, Windows, iOS or Android.

Connect the LED strip to the controller. Then connect the controller to the power supply and plug it into a power outlet.

Launch the Control Center app and pair Light Strip Pro by clicking the + icon. Control Center will guide you through the setup process.

For Wi-Fi pairing using a Mac, turn on your Light Strip Pro, click the Wi-Fi icon in the top right Status menu, and select your new accessory. After completing the Airport Utility setup process, your Light Strip Pro is accessible from Elgato Control Center.

Use Control Center to switch Light Strip Pro on/off, adjust brightness, fine-tune color, and set temperature.

If your PC is not equipped with Wi-Fi, use the Elgato Control Center app on your iOS or Android device to add Light Strip Pro. A Wi-Fi connection is only needed for initial pairing. Once paired, you can control Light Strip Pro via any wired or wireless device in your network.

RESET will restore Light Strip Pro factory settings and forget all Wi-Fi credentials. Push and hold the RESET Button with a small tool for at least 10 seconds until the light flashes 3x. Light Strip Pro will reboot automatically and re-engage pairing mode.

The device for operation in the band 5150–5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems.

Les dispositifs fonctionnant dans la bande 5150 à 5250 MHz sont réservés uniquement pour une utilisation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux.

Wi-Fi 2.4 GHz Max RF e.i.r.p power < 20 dBm, Wi-Fi 5 GHz Max RF e.i.r.p. power < 23 dBm, Temperature range: 0 °C - 45 °C

This equipment complies with FCC RF, IC RSS-102 and CE radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. For indoor use only.

Hereby, Corsair Memory Inc. declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EC. The declaration of conformity for Elgato products is available at www.elgato.com/doc