Elgato Embrace — Setup Guide

Setting up Embrace is quick. With only a few parts and one tool included, you can go from box to fully built chair in minutes.

This guide walks you through setup and tips so you’ll be sitting comfortably right away.

• Seat with armrests pre-attached
• Backrest
• Gas cylinder
• Optional headrest
• Five casters
• Base
• Six screws (four needed, two spares)
• Allen wrench

From start to finish, Embrace takes less than 5 minutes to assemble.

Step 1: Attach the casters

Turn the base upside down and press the casters into each socket until they click.

Step 2: Insert the gas cylinder

Flip the base upright and place the gas cylinder in the center opening, narrow end facing up.

Step 3: Mount the seat

Place the seat onto the gas cylinder and press down firmly.

Step 4: Attach the backrest

Slide the backrest into the seat brackets and secure with two screws using the Allen wrench.

Optional: add the headrest

Insert the headrest into the slot at the top of the backrest, then secure with two screws.

Adjustable headrest

Raise or lower the headrest and angle it until it supports the back of your head and neck.

4D adjustable armrests

Move up or down, forward or back, and angle in or out. Aim for elbows resting lightly and shoulders relaxed.

Height adjustment

Lift the lever to raise. Sit and lift to lower. Feet flat on the floor and knees near 90°.

Multi-lock reclining

Set how far the chair leans back and lock the position. If needed, adjust tilt tension with the knob so recline feels controlled.

Breathable mesh back

No setup needed. Sit upright with your back in contact with the mesh for support and airflow.

Adjustable seat depth

Hold the left lever and slide the seat forward or back. Leave 2–4 in (5–10 cm) between the seat and the back of your knees.

Waterfall seat edge

Sit so the front edge supports your thighs without pressing into your knees. Pair with seat depth for comfort.

Quiet casters

No adjustment needed after assembly. Make sure each caster clicked in fully; use a floor mat if you want less roll.

That’s it, your chair is set up. With everything in place, take a moment to adjust the height, armrests, and support until Embrace feels right for you. Now all that’s left is to sit down and enjoy.